Brocade_FCX

Sériová konzole 3 dráty, ale nekříží RXD a TXD.

      Baud: 9600 bps
      Data bits: 8
      Parity: None
      Stop bits: 1
      Flow control: None

Hesla

device(config)# enable super-user-password text

NOTE: You must set the super user password before you can set other types of passwords. Enter the following commands to set the port configuration and read-only passwords:

device(config)# enable port-config-password text device(config)# enable read-only-password text

Obnova hesla

Use the following procedure to recover from a lost password.

  Start a CLI session over the serial interface to the Brocade device.
  Reboot the device.
  While the system is booting, before the initial system prompt appears, enter b to enter the boot monitor mode.
  Enter no password at the prompt. (You cannot abbreviate this command.)
  Enter boot system flash primary at the prompt. This command causes the device to bypass the system password check.

FGS Boot Code Version 05.0.00 Enter 'b' to stop at boot … FGS-Boot> boot Boot system ip Set IP address monitor Toggle monitor mode reset Reset system show Show information FGS-Boot>monitor OK! The debug task will stop at start point. FGS-Boot>no password OK! Skip password check when the system is up. FGS-Boot>boot system flash primary

FastIron(config)# banner motd $ (Press Return) Enter TEXT message, End with the character '$'. Welcome to FESX! $ A delimiting character is established on the first line of the banner motd command. You begin and end the message with this delimiting character. The delimiting character can be any character except “ (double-quotation mark) and cannot appear in the banner text. In this example, the delimiting character is $ (dollar sign). The text in between the dollar signs is the contents of the banner. The banner text can be up to 4000 char acters long, which can co nsist of multiple lines. Syntax: no banner motd <delimiting-character> To remove the banner, enter the no banner motd command

banner motd $ *Unauthorized access prohibited * *Disconnect IMMEDIATELY if you are not an authorized user! * *This system is managed and monitored by jablonka.cz * *Contact info@jablonka.cz +420 777 99 15 69 *

$

buffer-sharing-full ! aaa authentication web-server default local aaa authentication enable default tacacs+ enable aaa authentication enable implicit-user aaa authentication login default local aaa authorization commands 0 default tacacs+ none aaa authorization exec default tacacs+ none aaa accounting commands 0 default start-stop tacacs+

boot system flash secondary Are you sure? (enter 'y' or 'n'): y Halt and reboot

ssh a konto a disable telnet config t crypto key generate rsa username konto pri 0 password heslo aaa authentication login default local no telnet server DHCP snooping enable ACL-per-port-per-vlan write memory exit reload

ip dhcp snooping vlan 50

interface ethernet 1/1/1 dhcp snooping trust

Tisk/export